162
CA116
Power Package Recommissioning
WARNING
To prevent possible injury or damage to equipment, do not in-
stall battery until all maintenance has been performed on en-
gine.
1 Check that all cooling system hoses are connected properly and
hose clamps are tight.
CAUTION
When installing battery, be sure to connect NEGATIVE (–) bat-
tery cable to NEGATIVE (–) battery terminal and POSITIVE (+)
battery cable to POSITIVE (+) battery terminal. If battery cables
are reversed, electrical system damage will result.
2 Install fully-charged battery. Clean battery cable clamps and
terminals and reconnect cables (see CAUTION listed above).
Tighten each cable clamp securely when connecting.
3 Coat terminal connections with a battery terminal anti-corrosion
agent.
To Next Page
Loading...
