147
76038
5
6
71216
4
CA897
NOTE: It may be necessary to lift or bend hoses to allow water to
drain completely.
4 Models equipped with circulating pump hose drain plug:
Remove drain plug.
5 Models without circulating pump hose drain plug: Loosen
hose clamps and disconnect hose from circulating pump. Allow
water to drain.
6 Make sure gear housing water vent and drain holes, speedometer
pitot hole and trim tab cavity vent and drain holes are open and
unobstructed.
7 Crank engine over slightly with starter motor to purge any water
trapped in seawater pickup pump. Do not allow engine to start.
8 After cooling system has been drained completely, install drain
plugs, reconnect hoses and tighten all hose clamps securely.
To Next Page
Loading...
