61
CA941
4 A 20 amp fuse may be located in ignition switch “I” terminal lead
to protect electrical system. Check for blown fuse if key is turned to
START and nothing happens (and circuit breaker is not tripped).
5 The Power Trim System is protected from overload by 110 amp
fuse and a 20 amp in-line fuse on Power Trim pump.
6 Quicksilver Three-Button Power Trim Control Panel is further pro-
tected by a 20 amp in-line fuse.
7 The Quicksilver MerCathode System has a 20 amp in-line fuse in
the wire which connects to positive (+) terminal on controller. If fuse
is blown, system will not operate and a loss of corrosion protection
will result.
To Next Page
Loading...
