IMPORTANT: If more than 59 ml (2 fl oz) of gear lube is required to fill the
monitor, a seal may be leaking. Damage to the drive unit may occur due to
lack of lubrication. Contact your authorized Mercury MerCruiser dealer for
service.
a - Gear lube monitor
b - "COLD FILL" line
Tube Ref
No.
Description Where Used Part No.
SAE 85W90
Mercury Racing
Gear Oil
Gear lube monitor 8M0078015
POWER TRIM PUMP FLUID
1. Place the drive unit in the full down/in position.
2. Remove the fill cap from reservoir and observe the fluid level. The level
must be up to, but not over, the bottom of the filler neck.
NOTE: Ensure that the cap plug has been removed and discarded from the
filler neck at first use.
a - Cap plug
Tube Ref
No.
Description Where Used Part No.
114
Power Trim and
Steering Fluid
Power trim pump reservoir 92-858074K01
MAINTENANCE
eng 55
To Next Page
Loading...
