8. Tighten the filter securely. Do not overtighten.
9. Remove the oil filler cap. Add oil to bring the level up to, but not over, the
"FULL" mark on the dipstick.
IMPORTANT: Always use the dipstick to determine exactly how much oil is
required.
a - Crankcase oil filler cap
Tube Ref
No.
Description Where Used Part No.
25W50 Synthetic
Blend 4-Stroke
Racing Engine Oil
Crankcase 8M0078013
CRANKCASE OIL AND FILTER (BOAT OUT OF THE WATER)
!
WARNING
Performing tests with the engine running may cause the propeller to rotate
and result in serious injury or death. Use caution when performing a test that
requires the engine running, and remove the propeller to avoid injury.
NOTICE
Operating the engine out of the water at high speeds creates suction, which
can collapse the water supply hose and overheat the engine. Do not operate
the engine above 1400 RPM out of the water and without sufficient cooling
water supply.
IMPORTANT: Change the oil only when the engine is warm from operation.
Use only the recommended motor oil; see Specifications
.
1. Provide cooling water to the engine.
2. Place the remote control into the neutral position and start the engine.
Operate the engine at idle or in neutral until the engine reaches normal
operating temperature.
3. Stop the engine, shut off the water, and remove the flushing attachment.
MAINTENANCE
60 eng
To Next Page
Loading...
