73
CB372
DRIVE UNIT AND TRANSOM ASSEMBLY
6 Lubricate gimbal bearing with Quicksilver U-joint and Gimbal
Bearing Grease.
7 For propeller shaft lubrication, see PROPELLER.
NOTE: Engine coupling and shaft splines are greased with Quicksil-
ver Engine Coupler Spline Grease, P/N 92-816391A4; universal
joints are greased with Quicksilver U-joint and Gimbal Bearing
Grease. Contact your Authorized MerCruiser Dealer for this service.
IMPORTANT: Stern drive must be removed to lubricate U-
joints. Contact your authorized MerCruiser dealer for this ser-
vice.
!
CAUTION
Speedometer water hose must be disconnected from drive unit
BEFORE removing drive unit. Failure to do this will result in a
broken fitting if drive unit is removed.
CB56
ENGINE COUPLER
8 Lubricate engine coupler splines with Quicksilver Engine Coupler
Spline Grease P/N 92-816391A4.
To Next Page