81
CB71
Cleaning Seawater (Raw Water) Section Of Heat
Exchanger And Oil/Power Steering Cooler -
Closed Cooling Models Only
Seawater sections of heat exchanger and oil/power steering cooler
should be cleaned at least once a year or whenever decreased cool-
ing efficiency is noticed.
HEAT EXCHANGER
5 Remove end plate(s), O-rings and gaskets. Inspect O-rings and
gaskets for deterioration and replace if necessary. Install gaskets, O-
rings and end plates. Tighten screws securely.
OIL COOLER/POWER STEERING COOLER
6 Remove end plates and gaskets. Inspect gaskets for deterioration
and replace if necessary. Install gaskets and end plates. Tighten
screws securely.
Start engine and inspect cooling system for leaks.
To Next Page
Loading...
