Maintenance
90-860174050 JUNE 2005 Page 45
2. Add the specified engine oil to bring the level up to, but not over, the full or OK range
mark on the dipstick. Recheck oil level.
3. Replace the fill cap.
Models Capacity Fluid Type
Engine Oil (With Filter)
4.7 liters
(5 U.S. Quart)
Mercury/Quicksilver Synthetic Blend MerCruiser Engine Oil
25W‑40
Changing Oil and Filter
Refer to the Maintenance schedule for the change interval. Engine oil should be changed
before placing the boat in storage.
IMPORTANT: Change engine oil when the engine is warm from operation. Warm oil flows
more freely, carrying away more impurities. Use only recommended engine oil (refer to
Specifications).
EASY ENGINE OIL DRAIN SYSTEM
NOTE: Boat must be out of water to perform this procedure.
1. Loosen the oil filter to vent the system.
2. Remove the bilge drain plug.
3. Pull tether through the bilge drain.
a - Binge drain plug
b - Tether
c - Clip
d - Oil drain hose plug
e - Oil drain hose
f - Bilge drain flange
4. Place the oil drain hose in a suitable container.
5. Remove the drain plug from the oil drain hose.
6. After oil has drained completely, install the drain plug in the oil drain hose.
7. Push the hose through bilge drain and install the plug.
ENGINE OIL DRAIN PUMP
1. Loosen the oil filter to vent the system.
2. Remove the dipstick.
To Next Page
Loading...
Need help?
General