60
of
OPERATION
gof89
9
8
6 75
off1
Starting The Engine – Tiller Handle Models
5 Side Handle Gear Shift Models – Set the gear shift to NEUTRAL position.
6 Turn Primer/idle speed knob full clockwise (direction of arrow) to increase
engine idle speed for starting.
7 When engine is cold, pull out and push in the primer/idle speed knob one to three
times to prime the engine. Leave the knob in the pulled-out position when
starting.
8 Manual Starting Models – Pull the starter rope slowly until you feel the starter
engage, then pull rapidly to crank the engine. Allow rope to return slowly. Repeat
until engine starts.
9 Electric Starting Models – Push starter button and crank the engine. Release
button when engine starts. Do not operate starter motor continuously for longer
than ten seconds at a time. If engine fails to start, wait 30 seconds and try again.
To Next Page
Loading...
