Mercury OUTBOARD MOTOR - Tilt Pivot Lubrication; Engine Oil Management; Changing Engine Oil Procedure; Engine Oil Capacity

MAINTENANCE
57
• Tilt Pivot.
ob00495
3. Lubricate the following with Quicksilver or Mercury Precision
Lubricants Anti‑Corrosion Grease or 2‑4‑C.
Tube Ref No. Description Where Used Part No.
94
Anti-Corrosion Grease Propeller shaft
92-802867A
1
95
2-4-C Propeller shaft
92-802859A
1
• Propeller Shaft ‑ Refer to Propeller Replacement for removal and
installation of the propeller. Coat the entire propeller shaft with
lubricant to prevent the propeller hub from corroding to the shaft.
ob00490
Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacaity is approximately 450 ml (15 fl. oz.).
OIL CHANGING PROCEDURE
1. Place outboard in an upright (not tilted) position.
2. Turn the outboard to gain access to the drain plug. Remove drain plug
and drain engine oil into an appropriate container. Lubricate the seal
on the drain plug with oil and reinstall.