EasyManua.ls Logo

Mercury V-6 series - Maintenance; Maintenance Aids

Mercury V-6 series
127 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
63
CA749
Maintenance
WARNING
Always disconnect battery cables from battery before work-
ing around electrical system components to prevent injury to
yourself or damage to electrical system should a wire be acci-
dentally shorted.
IMPORTANT: Refer to MAINTENANCE CHART for complete
listing of all scheduled maintenance to be performed. Some
listings can be done by owner/operator, while others should be
performed by an Authorized MerCruiser Dealer. Before
attempting maintenance or repair procedures not covered in
this manual, it is recommended that a MerCruiser Maintenance
Procedures Manual or Service Manual be purchased and read
thoroughly.
NOTE: Maintenance points are color coded for ease of identifica-
tion. See the decal on engine for identification.
Maintenance Aids
1 Power Steering System - Quicksilver Power Trim and Steering
Fluid or Dexron III automatic transmission fluid (ATF).
2 Propeller Shaft - Quicksilver Special Lubricant 101.
3 Sterndrive Unit - Quicksilver High Performance Gear Lube.
4 All Exterior Surfaces - Quicksilver Primer and Spray Paint and
Quicksilver Corrosion Guard.
5 Power Trim System - Quicksilver Power Trim and Steering Fluid,
or SAE 10W-30 motor oil.
6 Crankcase Oil - Quicksilver 4-Cycle Marine Engine Oil (Refer to
SPECIFICATIONS for alternatives and oil recommendations for
varying ambient temperatures.)
7 Closed Cooling System Coolant - Extended Life Ethylene Glycol
5/100 Antifreeze/Coolant mixed 50/50 with purified water. If this is
not available, use a 50/50 mixture of ethylene glycol antifreeze and
tap water. Areas where temperatures generally do not go below
32° F (0° C), rust inhibitor and tap water is acceptable.

Table of Contents

Related product manuals