97
CA116
Power Package Recommissioning
WARNING
To prevent possible injury or damage to equipment, do not in-
stall battery until all maintenance has been performed on en-
gine.
1 Check that all cooling system hoses are connected properly and
hose clamps are tight.
CAUTION
When installing battery, be sure to connect NEGATIVE (–) bat-
tery cable to NEGATIVE (–) battery terminal and POSITIVE (+)
battery cable to POSITIVE (+) battery terminal. If battery cables
are reversed, electrical system damage will result.
2 Install fully-charged battery. Clean battery cable clamps and
terminals and reconnect cables (see CAUTION listed above).
Tighten each cable clamp securely when connecting.
3 Coat terminal connections with a battery terminal anti-corrosion
agent.
4 Perform all checks in OPERATION CHART in the BEFORE
STARTING column.
CAUTION
Refer to FLUSHING COOLING SYSTEM before starting en-
gine.
5 Start engine and closely observe instrumentation to make sure
that all systems are functioning correctly.
6 Carefully inspect engine for fuel, oil, fluid, water and exhaust
leaks.
7 Check steering system, shift and throttle control for proper
operation.
8 Check fuel pump sight tube (if so equipped) for evidence of fuel
(indicating a ruptured fuel pump diaphragm).
To Next Page
Loading...
