13
The Batteries
Your scooter is equipped with a removable battery pack, which contains two
maintenance free, sealed lead-acid batteries. These batteries require no
maintenance other than ensuring they are properly charged. If other batteries
are
used, check with your battery supplier for proper battery care and maintenance
instructions.
To Charge
1.
Plug the charger’s power cord into the battery pack.
2.
If required, remove the battery pack.
3.
Pull the end of the rubber cover on the battery pack (as shown in photo). Then connect
the charger’s round plug into the charging socket.
4.
Switch on the plug socket.
The battery pack can be charged on-board the scooter (as shown) Alternatively, the
battery pack can be removed from the scooter and charged away from the scooter.
To Remove Battery Pack
1. Switch the ignition key off.
2. Lift the scooter battery pack up by the handle.
To Install Battery Pack
1. Remove the charger from the battery pack.
2. Drop the battery pack into the void on the scooter.
3. Press down lightly on the battery pack to ensure
it is securely installed.
Off board Charging
Removing battery
Onboard Charging
4. Ensure the charger is removed from the mains and the scooter or battery pack after charging. Failure to
do this may flatten he battery. Do not remove the battery pack while the scooter is switched on.
To Next Page
Loading...
