18
Assembling the Scooter
Use the procedure below to assemble the scooter:
1. Raise the tiller on the front section. Turn the
tiller adjustment knob towards the rear of the
scooter and then lift up on the tiller by turning
the knob towards the front of the scooter.
2. Connect the front and rear sections together.
Hold the back of the rear section and lift the
front section into place using the lever. Then
release the rear section and lower the front
section with the lever. Release the lever and
ensure the sections are securely linked.
3. Drop the battery pack into the void in the
scooter. Press lightly on the top of the battery
pack to ensure the battery pack is fully installed.
4. Insert the seat into the seat post. Push the seat
lever forward and swivel the seat until it locks
into position.
5. Place the basket into the front of the tiller.
To Next Page
Loading...
