15
USER´S MANUAL
Figure 11: Auto setup of parameters
5.6 Manual Setup of Parameters
The manual setup sequence is intended for experienced users. There are nine important
parameters to input before the controller can be taken into service. This sequence is
completed by an automatic verification of the parameters entered earlier in this sequence.
This menu item is a forced sequence, meaning that all items must be accessed before the
validation of the setup takes place.
The sequence can be interrupted by pressing key.
See Glossary (chapter 7), for parameter definitions.
In case of error, refer to the Commissioning Menu, chapter 5.4.
To Next Page
Loading...
Need help?
General
