7
Once you have completed your installation and
successfully carried out the safety reverse system test
(outlined above), install the warning labels provided
with your opener as shown.
The risk of entrapment label must be installed
adjacent to the release handle at a height of less than
1.8 m from the floor.
If required, use an eye bolt or hook (not included) to
guide the release handle rope.
The WARNING label must be installed in a prominent
place near any fixed control.
Any fixed wall control or wireless door control must be
mounted at a height of no less than 1.5 m out of the
reach of children.
Ensure the manual release instruction card is attached
to the rope as detailed in section 7.
Read the safety instructions (page 1) for further details
concerning safety.
FIXING WARNING LABELS
Operate the door in the down direction. The door must
reverse upon contact with the obstacle. If the door
stops on the obstacle, remove obstacle and repeat
limit and force setting (refer section 11).
Repeat test of the safety reverse system.
12
13
TESTING THE SAFETY REVERSE SYSTEM
The safety reverse system test is important.
The door must reverse on contact with a
40 mm obstacle laid flat on the floor. Failure
to properly adjust the opener may result in serious
personal injury from a closing door.
STANDARD INSTALLATION COMPLETE
To Next Page
Loading...