Need help?Do you have a question about the Mesa/Boogie 295 and is the answer not in the manual?
General| Type | Tube Power Amplifier |
|---|---|
| Channels | 2 |
| Tubes | 6L6 |
| Impedance | 4, 8 Ohms |
| Speaker Outputs | 2 x 1/4" |
| Power Output | 90 Watts (45 Watts per Channel) |
| Inputs | 2 x 1/4" (left and right channels) |
Explains the Simul-Class circuitry combining Class A and Class AB power for 95 watts per channel.
Details the 1/4" input jacks, including parallel inputs, and recommended preamp levels.
Describes the 8-ohm and 4-ohm outputs for speaker cabinets and impedance considerations.
Explains the function of the Power and Standby switches for amp operation and tube warm-up.
Covers the rear-panel presence switches for upper mid-range boost in loud situations.
Details the selection between Class A (30W) and Simul-Class (95W) modes for tone and volume.
Identifies MESA STR-420 (6L6) and STR-440 (EL-34) tubes and their roles in the amplifier.
Provides guidance on tube wear, troubleshooting, replacement, and handling precautions.
States that bias is permanently set during construction and requires no adjustment.
Discusses the 12AX7A driver tubes and the solid-state input stage for phase splitting.
To Next Page