EasyManua.ls Logo

Mesa/Boogie 50/50 STEREO TUBE

Mesa/Boogie 50/50 STEREO TUBE
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
50/50 STEREO TUBE POWER AMPLIFIER
Operating Manual
1
Question and Answer IconNeed help?

Do you have a question about the Mesa/Boogie 50/50 STEREO TUBE and is the answer not in the manual?

Mesa/Boogie 50/50 STEREO TUBE Specifications

General IconGeneral
TypeStereo Tube Power Amplifier
Power Output50 Watts per channel
Channels2
RackmountableYes
Tubes4 x 12AX7
Inputs2x 1/4"
Outputs2x Speaker Output
Impedance4, 8 Ohm
Dimensions19"

Summary

Inputs and Speaker Outputs

Inputs

Rear panel jacks for Channel A and B line-level signals from preamps or racks.

Speaker Outputs

One 8-ohm and two 4-ohm speaker outputs per channel for connecting cabinets.

Operational Controls

Power and Standby Switches

Controls AC power and tube warmup for extended tube life and surge prevention.

Level Controls

Individual channel controls for adjusting input signal sensitivity.

Lo Power Switch

Provides a 15-watt mode for tube distortion at moderate output levels.

Presence Controls

Boosts upper mid-range frequencies to help cut through loud mixes.

Tube Information and Maintenance

Tube Types and Lifespan

Details the MESA STR-420 6L6 GC power tubes, lifespan, and replacement.

Bias Adjustment

Bias is permanently set and requires no adjustment after tube replacement.

Driver Tubes

Describes the 12AX7A driver tubes and recommends genuine MESA replacements.

System Protection and Troubleshooting

Line Fuse

Protected by a 3 amp Slo-Blo fuse; specifies replacement type.

Ground Isolation Switch

Minimizes hum and buzz from ground loops in rack installations.

Related product manuals