Meta System EasyCan EVO Digital - Alarm System Activation; Emergency Deactivation; Electronic Key Self-Learning (OPT); Codice Override

18
ELECTRONIC KEY SELF-LEARNING (OPT)
After the battery has been re-connected, the siren emits a BOOP followed immediately by 2 BEEPs and 2 BOOPs
meaning that the key programming procedure has started. From this Instant and for the following 60 seconds,
self-learning of one or more of the electronic keys (Max. 4 Keys) is possible, putting them in the receptacle and
waiting for each one to con rm storage (the LED  ashes once). To skip the key combination procedure or  nish the
key storage phase, activate the +15 car panel twice.
NOTE: When self-learning is complete and one or more keys have been inserted, the inserted keys can be replaced
or others can be added only by using the programmer PRG007.
Emergency deactivation is also possible with the alarm system by entering the Override code using the Push
button/LED following the instructions in the user handbook or alternatively, combining the electronic keys as
illustrated below. For some Meta EasyCan EVO Digital product applications, emergency deactivation is available
using the original car key with transponder. To know on which car models the EMERGENCY DEACTIVATION
with original transponder is available, refer to the product/car list on the www.metasystem.it website.
EMERGENCY DEACTIVATION
CODICE OVERRIDE
The control unit is supplied with a customised Override Code and
you can  nd it on the “Factory code” sticker a xed on the control unit
itself. This means you do not have to customise it yourself. AFFIX the
“Factory code” sticker on the OVERRIDE-CARD which is in the
pack; for its use please follow the instructions given in the user
handbook. If you want to change the override code, do so using the
programmer PRG007.
Fig. 21
REPEAT FOR ALL
THE KEY TO BE
MEMORIZED
When you have  nished  tting the alarm and reconnected the battery negative to enable normal functioning of the
alarm system it must be activate following the steps of Fig.20.
NOTE: If you want add emergency electronic keys activate the alarm system following the steps of Fig.21.
ALARM SYSTEM ACTIVATION
Fig. 20
ALARM
SYSTEM
ACTIVATED