Alarm STATUS
LED
DIRECTION
INDICATORS
SIREN
Arming by remote control Button A
Slow ashing 2 Flashes 2 BEEP
Arming without tilt sensor, A then B
Slow ashing Flashes 2 + 1 2 BEEP + 1 BEEP
Arming with panel open
Slow ashing 2 Flashes 2 BEEP + 1 BOOP
Initial immunity phase
Fast ashing
Testing during the initial immunity phase
Fast ashing
1 BEEP with
each trigger
Alarm armed
Slow ashing
Alarm Triggered
Switches o Flashing Sounds
Disarming by remote control Button A
Switches o 1 Flash 1 BEEP
Disarming when the motorcycle’s
battery is fl at
Switches o 4 BEEP
Disarming when alarm triggers
have been memorised
Switches o brie y
every 6 sec.
1 BEEP + 1 BOOP
Pre-alarm phase
Switches o 5 BEEP
Service Mode
Flashing very fast
with ignition key ON
The LED will signal the trigger cause. If various alarms have been triggered,
the memory will signal
them in a sequence with 3 seconds pauses and will repeat the sequence every 6 seconds. The
memory is reset when the ignition is switch ON or the alarm system is armed with the remote
control again.
MEMORISED ALARMS LED SIGNALS
Internal movement sensor 1 Flash
Contacts 2 Flashes
Ignition key sensing 3 Flashes
Tampering with cables or battery 4 Flashes
BUTTON A
BUTTON B
The immobiliser arms automatically 50 seconds after ignition OFF, signalled by a short flash of
the direction indicators and a slow flashing of the LED.
2.. PASSIVE ARMING of IMMOBILISER
3.. Alarm Memory
To Next Page
Loading...
