The alarm protects the motorcycle against being started and an alarm cycle will be triggered
every time:
• The ignition key is turned ON
• An attempt is made to remove a protected panel (for example if the seat or the storage
c
ompartment is opened...)
• The motorcycle is moved
• The alarm power suppy is disconnected
4. PROTECTION
5. PANIC Function
It is possible to trigger a 10 second alarm cycle by pressing the B button on the remote control.
This alarm cycle can be interrupted by pressing the same button again.
To enable the SERVICE MODE turn ON the ignition and immediately after press hold the A
button of remote control for at least 6 secs; confirmation of mode ON is indicated by th
e
LED fl ashing quickly when the ignition ON.
To disable the SERVICE MODE turn ON the motorcycle’s key and immediately after press hold
the A button of remote control at least 6 secs; confirmation of mode ON is indicated by the LED
being off when the ignition ON.
Deep Sleep Mode is activated 5 days after the system was armed. The alarm protection remains
active but the remote receiver is switched off.
To exit from DEEP SLEEP MODE, turn the ignition key ON: the siren will emit a series of BEEP
sounds. Press the remote control within 20 seconds of the BEEPS to disarm the alarm system. If
the remote control is not pressed within 20 seconds, an alarm cycle will be triggered.
6. SERVICE MODE
7. DEEP SLEEP MODE
To Next Page
Loading...
