How to remove the cutting disc from a Metabo CS 23-355 Saw?
To remove the cutting disc from your Metabo Saw: First, press the lever for the spindle locking knob to the right and turn the cutting disc by hand until you feel the spindle locking knob engage. Then, use the wrench to remove the screw with the clamping flange anti-clockwise. Finally, remove the cutting disc.
How to fit the cutting disc on a Metabo CS 23-355 Saw?
To fit the cutting disc on your Metabo Saw, follow these steps: 1. Put on the new cutting disc. 2. Fit the screw with the clamping flange. 3. Use the wrench to lock the spindle and tighten the screw with clamping flange. 4. Check whether the spindle locking knob is completely disengaged again. 5. Clean the dirty machine and remove the grinding dust.
How to avoid crushing when lowering the lever on Metabo CS 23-355?
When lowering the lever on the Metabo Saw, be sure to keep your hands clear of the joint area to avoid the risk of crushing.
Ensures a clean, well-lit area, keeps bystanders away, and avoids hazardous environments.
Covers proper grounding, avoiding wet conditions, and cord safety to prevent electric shock.
Emphasizes staying alert, using protective equipment, and preventing unintentional starting.
Guidance on proper tool usage, maintenance, and handling to prevent accidents and damage.
General safety warnings specific to cut-off machines, including disc use and speed.
Explains kickback, its causes, and precautions to avoid it during operation.
Covers personal protective equipment, working with specific materials, and machine stability.
Instructions on how to preset the desired cutting depth using the limiter.
Guidance on clamping workpieces tightly and setting cutting angles and clamping width.
Steps and precautions for performing cuts, including reaching maximum RPM and contact pressure.
Describes the procedure for operating the trigger switch to turn the machine on and off.
Instructions on how to secure the machine for transport using the lever and lock.
General| Input power | 2300 W |
|---|---|
| Cable length | 2.7 m |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Noise level | 104 dB |
| Idle speed (max) | 4000 RPM |
| Diamond disc | - |
| Saw blade included | Yes |
| Suitable for materials | Metal |
Weight and Dimensions| Depth | 282 mm |
|---|---|
| Width | 468 mm |
| Weight | 16900 g |
| Blade diameter | - mm |
To Next Page
