What to do if my MetalMaster Cutter won't cut?
If your MetalMaster Cutter won't cut, it could be due to low system oil pressure or excessive clearance/damage to the cutting edges of the blades. In both cases, you should check the system pressure, oil level, blade gap, and blade clearance. Reset or regrind the blades as required.
Why is the MetalMaster HG-3206 Cutter leaking oil from the fittings?
If oil is leaking from the fittings of your MetalMaster Cutter, it's likely because the fittings are loose. You should tighten the fittings to resolve this issue.
What to do if clamping doesn't work on my MetalMaster HG-3206 Cutter?
If the clamping mechanism on your MetalMaster Cutter isn't working, the cause might be no clamping pressure. You should check the system pressure and the electrical circuit.
What to do if my MetalMaster HG-3206 Cutter won't stop in the neutral position?
If your MetalMaster Cutter won't stop in the neutral position, check the limit switch/relay and the directional control valve. Replace them if necessary.
How to fix oil leaking from the cylinder of my MetalMaster HG-3206 Cutter?
If oil is leaking from the cylinder of your MetalMaster Cutter, the gland seal is likely damaged. You should change the seal.
Why does my MetalMaster Cutter shudder on the down stroke?
The shuddering of your MetalMaster Cutter on the down stroke is due to an incorrect relief valve setting. Re-adjust the relief valve by unlocking the hexagon head grub screw on the side of the valve body. Turn it in a clockwise direction, closing the valve while cycling the machine.
Detailed specifications for different Metalmaster guillotine models, including dimensions and capacities.
Outlines essential safety rules and procedures for operating the guillotine safely.
Details the machine's built-in safety features, such as emergency stops and guards.
Detailed guide for aligning the safety sensors for correct operation.
Steps to perform before starting the machine to ensure safety.
Explains the functions and operation of the NC89 control panel.
Guide on how to adjust the blade gap for different material thicknesses.
Guide to diagnosing and resolving common machine issues.
Specific safety directives for operating power-driven guillotines.
General| Type | Plasma Cutter |
|---|---|
| Input Current | 32A |
| Input Voltage | 220V |
| Duty Cycle | 60% |
| Protection Class | IP21 |
To Next Page
