What to do if my MetalMaster HG-3212 Cutter won't cut?
If your MetalMaster Cutter won't cut, it could be due to low system oil pressure or excessive clearance/damage to the cutting edges of the blades. In both cases, you should check the system pressure, oil level, blade gap, and blade clearance. Reset or regrind the blades as required.
Why is the MetalMaster HG-3212 Cutter leaking oil from the fittings?
If oil is leaking from the fittings of your MetalMaster Cutter, it's likely because the fittings are loose. You should tighten the fittings to resolve this issue.
What to do if clamping doesn't work on my MetalMaster HG-3212?
If the clamping mechanism on your MetalMaster Cutter isn't working, the cause might be no clamping pressure. You should check the system pressure and the electrical circuit.
What to do if my MetalMaster HG-3212 Cutter won't stop in the neutral position?
If your MetalMaster Cutter won't stop in the neutral position, check the limit switch/relay and the directional control valve. Replace them if necessary.
How to fix oil leaking from the cylinder of my MetalMaster Cutter?
If oil is leaking from the cylinder of your MetalMaster Cutter, the gland seal is likely damaged. You should change the seal.
Why does my MetalMaster Cutter shudder on the down stroke?
The shuddering of your MetalMaster Cutter on the down stroke is due to an incorrect relief valve setting. Re-adjust the relief valve by unlocking the hexagon head grub screw on the side of the valve body. Turn it in a clockwise direction, closing the valve while cycling the machine.
General| Brand | MetalMaster |
|---|---|
| Model | HG-3212 |
| Category | Cutter |
| Language | English |
Outlines critical safety rules and precautions for operating the guillotine, emphasizing personal protective equipment and safe practices.
Procedure for aligning the photoelectric safety sensors and resetting the safety circuit.
Steps to calibrate the backgauge "X" axis on the controller for accurate positioning, including access code.
A checklist of all necessary checks, from installation to operation manual review, before final machine use.
Essential safety checks to perform before starting the machine, including guards, sensors, and emergency stops.
How to use the NC89 controller for backgauge positioning, cut count, timer settings, and mode selection.
Guide on adjusting the blade gap based on material thickness and type using the adjustment table and hand wheel.
To Next Page
