18
meteo – SP89 Manual
Setup Preparation
Items you will need to setup your station (not included):
1. Crosshead screwdriver and hex driver for assembly.
2. Fresh Batteries:
2 (two) AA alkaline or lithium batteries for the weather station.
3 (three) AA alkaline or lithium batteries for the multi-combination sensor.
2 (three) AA alkaline or lithium batteries for the temperature | humidity sensor (Optional)
For best results:
• Remove weather station and sensors from the package and place together on a table or bench, within easy reach.
• Place batteries and screwdriver within reach of setup location.
• Keep sensors and weather station 0.15-0.3 meter or 5-10 feet for at least 15 minutes after installing batteries, to
allow the sensors and station to connect repeatedly.
Quick Setup
1. Insert 3 AA batteries into the multi-combination wireless remote sensor
2.3-AA battery entry temperature | humidity wireless remote sensor
3. Then plug the power cord into the weather station
4. Configure basic settings. Set time, date, unit, etc.
5. Insert 2 AA batteries into the weather station (when the power adapter is unexpectedly powered off, the settings will not
be lost)
6. Move the remote sensor to outdoor or other location after 5 minutes
7. Move the weather station to the appropriate location, with a minimum distance of 2.5 meters from all sources of
interference, such as a television or computer monitor,
radio reception is weaker in rooms with concrete walls (e.g.: in
cellars) and in offices. In such extreme circumstances, place the weather station close to the window.
Note:
The weather station has a radio control clock calibration time function. After power-on, after searching the
wireless sensor for 3 minutes or all channels successfully search for the wireless sensor, the weather station
will automatically enter the radio control clock timing mode. If you need to set the time and unit manually, you
need to press and hold the "" button to exit the radio time mode, and then continue to the next step.
Time and unit settings
Press and hold the “ ” button for 3 seconds to enter the time setting mode.
Press and release the “ ” or “ ” button to adjust the value. Hold the “ ” or “ ” button to adjust quickly.
Press and release the “ ” button to confirm and move to the next item.
Note: After 20 seconds without pressing any button or touch the “ ” location button at any time to exit the
settings.
Settings order:
1. BEEP ON/OFF
2. Temperature unit: °C | °F
3. Pressure unit: hPa| inHg | mmHg
4. Wind speed unit: KM/H |MPH
5. Wind degree (angle) or direction (letter) selection
6. Rainfall unit: MM| inch
7. Radio control clock function: ON |OFF
Note: When the weather station is in the same
area as Germany, the time zone is set to 00, one
hour slower than German time, the time zone is set
to -01, one hour faster than German time, the time
zone is set to 01, 2 hours faster than German time,
time zone Set to 02
To Next Page
Loading...