To Next PageTo Next Page
Need help?Do you have a question about the Metra Electronics 95-8208 and is the answer not in the manual?
General| Brand | Metra Electronics |
|---|---|
| Model | 95-8208 |
| Category | Automobile Accessories |
| Language | English |
Disconnect the negative battery terminal to prevent an accidental short circuit.
Unclip and remove panels from the left and right side of the radio.
Unclip and remove the panel or speaker cover located above the radio.
Remove four 10 MM bolts securing the radio, then unplug and remove it.
Snap the Double DIN brackets to the inside edge of the radio housing.
Slide the Double DIN radio into the bracket/housing assembly and secure it with the supplied screws.
Snap the Double DIN Trim plate into the Radio Housing.
Snap the Double DIN brackets to the inside edge of the radio housing.
Slide the stacked ISO units into the bracket/housing assembly and secure them with the supplied screws.
Snap the Double DIN Trim plate into the Radio Housing.
Locate factory wiring harness, use mating adapter, and make connections, isolating unused wires.
Reconnect the negative battery terminal and test the unit for proper operation.
Reassemble the radio and dash assemblies in the reverse order of disassembly.
Details the Metra/EIA wiring code for making correct audio connections.
