Metra Electronics 95-8212 - Page 3

95-8212
4. Unclip and remove the pocket and
seat heater switch panel.
(Figure D)
5. Remove (4) 10mm screws
securing the radio/climate control
assembly, and then unplug and
remove the assembly. (Figure E)
6. Remove (3) Phillips screws
securing the climate controls to the
factory brackets, and then remove
the climate controls from the
assembly. (Figure F, G)
Note: Retain the climate controls
and screws for reuse in kit
assembly.
Continue to kit assembly
Dash Disassembly
(Figure D) (Figure F)
(Figure E) (Figure G)
3