Metra Electronics 99-2008 - ISO Mount Radio Provision with Pocket Assembly

99-2008 KIT ASSEMBLY
4
ISO MOUNT RADIO PROVISION WITH POCKET
Mount the ISO Brackets to the radio
using the screws supplied with the
radio.
(Figure A)
1
Slide the radio into the radio housing
until it snaps into place. (Figure B)
2
Snap the trim plate onto the front of
the radio housing. (Figure B)
3
4
Continue to final assembly.
*Note: Refer also to the instructions included with the aftermarket radio.
A
B
C
Snap the pocket into the housing.
(Figure C)