99-5721 KIT ASSEMBLY
9
screen will then be displayed and the cursor will appear and blink. It will be
located in the 1st location on the top row.
2. To modify the text :
A. Use the FAN buttons to move the cursor forward or back. The
location where the cursor is blinking is the location that the character
may be changed.
• FAN DOWN = Move Cursor ahead one location
• FAN UP = Move Cursor back one location
B. To change the character where the cursor is currently blinking use the
TEMP buttons to progress through the character set.
• TEMP UP = Show the next character
• TEMP DOWN = Show the previous character
3. To exit this mode:
A. Do not press ANY buttons for 15 seconds and it will timeout
automatically.
B. Press button other than the 4 mentioned above.
4. To erase any changes made to the default display – Press and hold down the
recirculation button button for 15 seconds. The “TAURUS” will once again be
the default display.
NOTE : Characters are saved into memory immediately whenever changes are
made.
NOTE : While in this mode – no other display items will be updated.
To Next Page
Loading...
