Metra Electronics 99-5800 User Manual

KIT COMPONENTS
KIT FEATURES
DIN unit
provision
Equalizer
provision
Pocket
provision
99-5800
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
FORD
Expedition 1997-98.........................................1-3
F-150 1997-98...................................................1-3
TOOLS REQUIRED
Cutting tool
Socket set
Dremel tool
86-5618 - Head unit
removal keys
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
6 7
Re-connect the battery terminal and test the unit
for proper operation. Snap the head unit/kit
assembly into the sub-dash.
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Radio Housing
5
DIN HEAD UNITS: Slide the DIN cage into the Radio Housing and secure by bending the
metal locking tabs outward. Slide the aftermarket head unit into the cage until it snaps into
place.
3
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 4-10-08

Metra Electronics 99-5800 Specifications

General

Manufacturer	Metra Electronics
Part Number	99-5800
Product Type	Dash Kit
Color	Black
Material	Plastic
ISO DDIN radio provision	Yes
Wiring Harness	Not Included
Antenna Adapter	Not Included

Summary

Applications

Ford Expedition 1997-98

Ford F-150 1997-98

Installation Step 5: DIN Head Unit Installation

Secure Cage and Install Head Unit

Instructions for securing the DIN cage and sliding the aftermarket head unit into place.

Installation Step 6: Wiring Harness

Wire Preparation and Connection

Details on stripping wire ends, twisting, soldering, and taping for connections.

Installation Step 7: Final Assembly

Battery Reconnection and Sub-Dash Fitment

Procedure for reconnecting the battery and fitting the assembly into the dash.

All Vehicles - Installation Steps

Disconnect Battery and Remove Dash Bezel

Steps to safely disconnect the battery and remove the factory radio trim bezel.

Remove Rear Support Bracket

Instructions for removing the rear support bracket from the dash cavity.

Modify Dash Cavity for Upper Radio Position

Trim Radio Housing Clips for Lower Position

Install Equalizer into Radio Housing