BT-HD01
2
Pre-Installation
• Turn the radio on and activate the FM source.
• Turn the ignition key switch to the off position.
• Press and hold any (2) soft buttons on the radio, and then turn the ignition key switch to the on position. The soft buttons are the numbered buttons on the radio.
• Continue holding the (2) soft buttons until “Diag Test” is displayed on the radio screen, and then let go.
• Press the soft key button “4” labeled “Software” on the radio screen.
• The radio screen will then show the current software version. If you do not have V8.250 or higher, please go to the following website to update the radio:
http://www.harleydavidson.com/en_US/Content/pages/genuine_motor_accessories/advanced-audio-system.html
• Follow the instructions on the website exactly as stated. If there are any questions with that process, contact Harley Davidson. Please do not contact Axxess/Metra for
any questions pertaining to updating the radio.
• If the radio has V8.250 or higher software, press the soft button “6” to exit the diagnostic mode.
Attention: Before beginning the installation, check the current software version of the radio following the steps below.
This product will not work on models with software versions lower than V8.250.
To Next Page
Loading...