8
www.portableappliancetesters.com.au/support
Plug the transformer into the battery and the wall adaptor into the wall power outlet; ensure that the battery
is turned on while charging. There should be an LED illuminated on both the transformer and
wall adaptor.
The transformer will glow orange during charging and then green when fully charged. This can take upto 6 hours to
fully charge from flat.
To run the printer off mains power, you will need to lift
the printer out of the foam casing, disconnect the lead
from the printer to battery and replace it with the mains
power lead as seen above.
Then connect the 240v power plug to mains power and
the printer should turn on with a green light.
To Next Page
Loading...
