Portable 4000 count digital multimeter
18
1.6 Unpacking - Repackaging
This equipment has been fully checked out mechanically and
electrically before shipping.
All precautions have been taken to ensure that the instrument arrives
at its destination undamaged.
However, it is advisable to carry out a rapid check for damage
sustained in shipping. If there is any evidence of damage, make this
known immediately to the shipper.
Should you need to return the multimeter, preferably use the
original packaging and indicate the reasons as clearly as
possible on an accompanying note.
1.7 Cleaning
Clean the instrument using a damp cloth and soap. Never
use
abrasive or solvents.
1.8 Replacing the battery or fuses
First disconnect test leads from any circuit under test, turn the
meter off and remove test leads from the input terminals .
Use the following procedure :
1 - Using an appropriate tool, slide off the case bottom of the
instrument.
2 - Replace the battery or the fuse.
3 - Replace the removable part.
HBC fuses must be replaced by fuses of the same rating and type.
BATTERY 9 V
6LF22
F1 0.63 A, HBC
18 kA / 600 V
F2 10 A, HBC
50 kA / 600 V
To Next Page
Loading...
Need help?
General
