Page 16 of 25
Printing Configuration Setpoints: The following applies if a printer has been installed or a PC is connected to the RS232 com
port using a null modem cable. When the [PRINT] button is pressed while looking at a configuration setpoint screen, a menu for
what is to be printed is displayed. Pressing [1] prints just the set point screen currently being displayed. Pressing [2] prints all the
set points in the section of set points currently displayed. Pressing [3] prints all the set point screens of all five set point sections.
NOTE: when printing all set points, only Aux#01 User Programs 501 through 515 will be printed. To print any of the remaining
eleven aux alarm settings, press [PRINT] when inside the appropriate Aux alarm and select [2] for “2) PRINT 500 SETPTS.”
The 501 through 515 Aux User Programs for that aux alarm will be printed.
101 SYSTEM SETPOINTS
Pump Start
Pressure
[ 60] psi 0-999
PRINT OPTIONS
1) PRINT THIS SETPT
2) PRINT 100 SETPTS
3) PRINT ALL SETPTS
Typical Configuration Setpoint
Printout
101 SYSTEM SETPOINTS
Pump Start
Pressure
[ 60] psi 0-999
102 SYSTEM SETPOINTS
Pump Stop
Pressure
[ 90] psi 0-999
103 SYSTEM SETPOINTS
Pump Start Delay
Time
[ 10] seconds 0-999
“ “
“ “
“ “
509 AUX USER PROGRAMS
Aux Alarm #01
2nd Control Output
[ 0] 12-25
510 AUX USER PROGRAMS
Aux Alarm #01
3rd Control Output
[ 0] 12-25
To Next Page
Loading...
Need help?
General
