LNB cable installation
(See the installation diagram on the next page)
For the installation of the F connectors on the coaxial cable you
need a knife (ideally a wire stripper) and side cutting pliers.
Ö Cut 8mm of the coaxial cable at each end up to the inner core.
Ö Carefully cut 10mm of the outer insulation so that the wire
netting is exposed.
Ö Turn the wire netting backwards and wind it over the outer
insulation in such a manner that it does not touch the inner core.
Ö Remove the inner insulation up to 2mm from the wire netting.
Ö Rotate the IF connector onto the turned-back wire netting till the
connector touches the inner insulation.
L
The wire netting must not protrude from the back of the
connector end.
Ö Cut the inner core with a cable cutter in such a manner that it
projects maximum 1mm from the connector.
18
To Next Page
Loading...
