INTRODUCTION
SAFETY PRECAUTIONS:
This unit operates with high voltages. Servicing of the Sonicator ME 706should be referred
to qualified service technicians or returned directly to the factory. To assure continued
compliance with FDA, 21 CFR 1050.10 standards, the ME 706 should be factory calibrated
and safety
tested
at least once
each
year. Mettler Electronics recommends
that
all service
work be performed at the factory. However, a service manual
can
be obtained by writing the
factory for those who are qualified to service the device and are
fully
aware of their
responsibilities.
CLEANING INSTRUCTIONS:
To clean the molded plastic enclosure of the Sonicator ME 706 generator housing or
applicator handle, use a mild detergent with a damp soft cloth. Use of any other cleaning
agent or solvent is not warranted or recommended.
SHIPPING:
The
instrument is shipped complete in one carton containing the unit itself, a wallmounting
plate with three screws, guarantee card, operating instructions
and
one
tube of Sonigel
coupling agent. We recommend
that
you retain the shipping
carton
in the event you need to
return the unit for factory servicing.
UNPACKING
AND
INSTALLATION:
Upon receipt of the unit, check for visible and hidden damage. If any damage is apparent
upon opening
the
case, hold all shipping materials including the case
and
call the shipping
agency which delivered
the
unit. They are responsible for all damage in transit; therefore, all
claims should be fileddirectly with them.
The
factory
will
not be responsible for any damage in
shipment, nor allow any adjustment unless proper formal claim has beenfiledby the receiver
against the carrier.
The unit
operates
on 120volts, 60 hertz alternatingcurrent. (Other voltages are available.)
Unless your voltage
and
frequency
are
as above, DO
NOT
CONNECT
THE UNIT TO
YOUR SUPPLY.
If only direct
current
(DC) is available use a converter that provides 120
volts AC, 60 hertz with a capacity of 100 watts.
WALL MOUNTING:
To fasten the mounting plate on a wooden surface, use the three screws included with the
unit. On a dry wall or plaster surface, use two "well-nuts". Position
the
plate with the slot
facing upward
and
angled
out
from the wall.Lower the mountingscrew(locatedon the upper
back of the unit) firmly into the mounting plate slot.
CAUTION:
Federal law restricts this device to sale or on the order of a physician, dentist, veterinarian,
or any other practitioner licensed by the law of the state in which he practices to use or order
the use of this device.
Use of controls or adjustments or performance of procedures
other
than
those specified
herein may result in hazardous exposure to ultrasonic energy.
Electric treatment tables or whirlpools which may come in contact with the patient during
a treatment with
the
Sonicator ME 706, should be adequately grounded
and
safety tested
to insure safe operation with
the
Sonicator ME 706.
1
To Next Page
Loading...