Sonicator 740 Instruction Manual— Rev.G_06/28/12
33
Section 9—Specifications
9.1 General Specifications:
Input: 100–240 VAC, 50/60 Hz, 1.0 amperes maximum
External Fuse: 1.0 A, 250 V, GDC/S506
5 x 20 mm time delay
2 x T1.0 AL250 V
Optional Battery: Rechargeable Smart Lithium Ion Battery Pack rated at 10.8Vand 4.8Ah.
Certification: The Sonicator 740 complies with the ultrasound performance standards set
forth in the Code of Federal Regulations, Title 21 (Food and Drugs),
Part 1050.10.
ETL and C-ETL Listed: Model ME 740 (9801427)
Classification: Protective Class I Equipment and Internally Powered Equipment
Type B Equipment
Enclosed equipment without protection against ingress of water.
Equipment not suitable for use in the presence of a flammable anesthetic
mixture with air or with nitrogen oxide.
Treatment timer
Indicator: The digital timer indicates time set in minutes and seconds prior to the start
of treatment and treatment time remaining during treatment or when
treatment is temporarily suspended. If no treatment time is set the timer
will
count up to 30 minutes and then treatment will stop.
Accuracy: ±0.5 minute for times less than 5 minutes
±10% for times from 5 to 10 minutes
±1.0 minute for times greater than 10 minutes
Maximum treatment time: 30 minutes
Size: 13.5 in (L) x 9.5 in (W) x 7 in (H)
Weight: 3.75 pounds without battery
4.5 pounds with battery
Temperature:
Operating: 50°F to 104°F
Non-Operating: -40°F to 167°F
Humidity: Operating, 30% to 75% Relative Humidity at 104°F
Non-Operating, 5% to 95% Relative Humidity, non-condensing
9.2 Ultrasonic Generator Specifications:
Frequency: 1.0 MHz ±10%
3.2 MHz ±10%
3.3 MHz ±10%
Modes: Continuous
Pulsed 10, 20 and 50% Duty cycle
Pulse repetition rate: 100 Hz ±5% (Pulse Mode)
Pulse duration: 1, 2 or 5 msec ±5%
Temporal peak/average
intensity ratio: 10:1, 5:1 and 2:1 ±5%
To Next Page
Loading...