Dis-Mount Plow From Vehicle
For Mounting and Dis-mounting instructional video’s please visit www.youtube.com/meyerproducts
Meyer Products assumes no responsibility for installations not made in
accordance with these instructions.
(8)
WingMan 2" Receiver Mounting System – Dismount/OFF
1. Press down button until Float light turns Blue/on.
1
4. Attach crankstand to a-frame..
4
5. Adjust crankstand until crankstand comes into
contact with the ground and then turn 1 to 2
revolutions.
5
8. Back vehicle away from plow assembly.
8
3
3. Remove crankstand from lift frame.
6. Remove hair pin and pull out receiver hitch pin.
6
2. Push lift arm down until there is a little slack in the chain.
2
7. Disconnect both electrical plugs and install weather cover
on both ends.
7
8
To Next Page
Loading...