MFJ MFJ-1886TR - Wiring; What You Will Need; Mounting

Mounting
Customersuppliedtripodormast
Usethetwosuppliedu-bolts
tosecurethelooptoyour
mastasshown. Yourmast
shouldbenomorethan
1-3/4indiameterandshould
besturdyenoughtosupport
theMFJ-1886antenna.
Sideview
Transmit Antenna
XCVR
ANT
KEY Line
DCPASS
LOOP ANTENNA
Line
1.Connectacoaxjumperbetweenthe
transceiverandthe TRANSCEIVERjack.
2.Connectthe Transmit AntennatotheXMIT
ANTENNA jack.
3.ConnectthecoaxbetweeltheMFJ-1886Loop
andtheLOOP ANTENNA DC-PASSjack
4.ConnectandRCA cablebetweentheKEY jack
andtheKEY outputonthetransceiver. This
maybelabeledSENDormaybeonajack
labeledREMOTEor ACCESSORY. Thisisthe
linethatwouldbeusedtokeyalinearamplifier.
5.Connectupthe12VDCpowersourcethat
camewiththeMFJ-1886.
1
2
3
4
5
Wiring
What You WillNeed
1.CoaxJumperbetweentheSwitchBoxand
thetransceiver
2.CoaxjumperbetweentheLoopandthe
SwitchBox.
3. Transmit Antenna.
4.InterfacecabletorunbetweentheKEY
inputandthetransceiverSendoutput.