Front
ventilator
windows
Fig.
9
To open, move the catch lever
(1)
upwards and push the window outwards.
To close, pull the catch inwards and then push it forward until the catch is in
the locked position.
Rear
ventilator
windows
Fig.
70
Body and door
drainage
points
Fig.
7
I
Fig.
9
To open, pull the catch
(1)
forward and then push the catch outwards.
To close, pull the centre of the catch inwards and then push it backwards until
the catch, snaps over into the locked position.
Periodic examination of the drain holes should be made to ensure that they
are clear of obstruction; use a piece of stiff wire to probe the apertures.
Careless application of underseal can result in restricted drainage. Masking
tap
or plugs used when underseal is being applied must be removed immediately the
operation is completed.
Jacking up beneath the underfloor may deform the drain apertures; always use
the jacking points provided.
Fig.
10
Fig.
l
l
To Next Page
Loading...
