Electrical
Centre console
To gain access to the bulbs the centre console must be withdrawn.
warning and
illumination Centre console.
Remove the gear lever knob and locknut
(l).
Unscrew the four
Fig.
74
screws
(2)
securing the gaiter retaining ring. Raise the hinged arm-rest, unscrew
the retaining screw
(3)
and remove the arm-rest complete with gaiter
(4).
Un-
screw the four screws
(5)
retaining the console and withdraw the console
(6)
rearwards.
Heated rear window warning lamp
(iffirred).
A
screw fixing bulb. Withdraw the
centre console. Remove the push-fit bulb holder
(7)
from the lamp and unscrew
the bulb
(8).
Cigar-lighter illumination bulb
(iffitted).
A
bulb with bayonet fixing. Withdraw
the centre console. Squeeze the sides of the bulb hood
(9)
and remove the hood.
Remove the bulb holder
(10)
from the hood clip and remove the bulb
(11).
Warning
The warning and panel lamps are a push-fit into the back of the instrument and
and panel
warning lamps, and are located in the positions shown.
Fig.
I5
(1)
Fuel gauge and temperaturelwater gauge illumination lights.
(2)
Ignition and main beam warning lights.
(3)
Speedometer and tachometer illumination, and direction indicator warning
lights.
The lamps are accessible from below the fascia panel. Remove the push-fit bulb
holder and unscrew the bulb from the holder.
Fig.
14
To Next Page
Loading...
Need help?
General
