Procon
. S T (’)
Essential Parameter Changes Applicable to System Type .
Line ID Description
Default
Setting
New Setting for
This System
H Summer/Winter Changer Over
H-b
Heating Zone Flow Sensor Present
{ = NO, = YES}
H-b
HWS Charging Pump (Standing Operation) {, }
{ = OFF, = ON}
Potential Parameter Changes Applicable to System Type .
Line ID Description
Default
Setting
New Setting for
This System
H
Minimum ow setpoint temperature Heating Zone
( °C ≤ TvSmin ≤ TvSmax)
As Required
H
Maximum ow setpoint temperature Heating Zone
(TvSmin ≤ TvSmax ≤ °C)
As Required
H-b
Heating Zone Flow Sensor Present
{ = NO, = YES}
As Required
H-b
HWS Charging Pump (Standing Operation) {, }
{ = NO, = YES}
As Required
Fig .c – Wiring Diagram for Model
Notes
* Only t one type of Room
Temperature Control.
* Parameter Change may be
required.
* Heating Zone
* Heating Zone , via AGU.
Clip-In Module.
To Next Page
Loading...
