Mounting point is
over 1.9 m above the floor
Facing downwards
Mounting point is between
0.5–1.5 m above the floor
Facing straight forward
Select a flat and dry mounting surface, wipe the surface clean first, and then peel
off the release liner from the base. Stick the base in the desired location and press
it down firmly to make sure it is properly secured. Finally, aach the light to the
magnetic base and adjust it to a suitable angle. Make sure it is firmly installed
with the magnet, so as to avoid the risk of accidental dropping.
Note: For accurate detection, it is recommended to face the light downwards when the
base has been mounted over 1.9 m above the floor.
3. Mounting the light
03
EN
To Next Page
Loading...
