Copyright © 2009-2016 Micca. All rights reserved. Page | 1
1 Introduction
Thank you for your purchase! The OriGen+ USB audio DAC and preamplifier is a studio master
grade digital audio playback device that supports high resolution PCM audio up to 24-bit/192kHz
and DSD64 audio. Use the OriGen+ to bypass your computer's soundcard and unlock the full
potential of your music.
1.1 Features
1.1.1 Input and Output
Asynchronous USB 2.0 input for use with Windows XP/7/8/8.1/10, and MAC OSX.
Optical S/PDIF digital input. Switch selectable between USB or Optical input.
Front 3.5mm and 1/4” stereo headphone outputs. Powerful built-in headphone amp supports
16-600 Ω headphones. Switch selectable between headphone or rear analog stereo output.
Rear 3.5mm analog stereo and combination optical S/PDIF digital output.
1.1.2 Digital Stream Formats
PCM audio up to 24-bit/192kHz over USB and Optical inputs
DSD64 (2.8MHz), Native or DoP over USB input
ASIO support over USB input
WASAPI Push/Event support over USB input
1.1.3 Key Components
VIA VT1736 USB 2.0 High Speed 480Mbps audio controller
Cirrus Logic CS4392 Stereo D/A Converter
JRC NJM4556 operational amplifier
1.1.4 What’s Included
Micca OriGen+ unit
USB cable
3.5mm to RCA audio cable
User’s Manual
Note: All the information contained in this manual was correct at the time of publication.
However, as our engineers are always updating and improving the product, your device’s
software may have a slightly different appearance or modified functionality than presented in
this manual.
To Next Page
Loading...