Copyright © 2009-2012 Micca, LTD. All rights reserved.
Do not plug/unplug the HDMI output with the power connected to the
player. Doing so may damage the player.
The Micca Speck must be set to a valid HDMI output mode for the HDMI connection to
output a correct signal. If there is no picture or the picture is distorted after connecting
the HDMI output, press the <HDMI> button on the remote to set the player’s output
mode to 720p. Other HDMI display modes can then be set through the Setting menu.
D. Auto Detect AV Output
The HDMI and AV outputs cannot be used at the same time. By default, the Micca
Speck is configured to automatically detect the optimal AV output to use. If an HDMI
connection is detected when the player is turned on, the player set its video output
mode to HDMI. If HDMI connection is not detected, but an AV connection is detected,
the player will automatically set its video output mode to AV.
This auto output detection feature can be disabled by setting “Auto HDMI Detect” to
“OFF” in the settings menu. When the auto detection is turned off, the player will only
use the video output mode that is configured in the settings menu. The video output
mode can still be changed using the <AV> and <HDMI> buttons on the remote control.
To Next Page
Loading...
