If you are inflating multiple tyres and you unplugged the power between tyres you will have to reset the
inflation mode, pressure format and target pressure (if different from the default settings.) The inflator
does not have an inbuilt memory.
Ball mode: default pressure (flashing) is 8 psi. Adjustable range: 2-16 psi.
Free mode: default pressure (flashing) is 0 can be adjusted freely under free mode.
Adjustable range: 3-100 psi.
psi
psi
psi
psi
3. Check the tyre pressure shown on the display. When connected correctly the gauge will display the
current pressure in the tyre. If this is the pressure as stated in your vehicle’s handbook, you can simply
remove the tyre valve connector (7). If the tyre pressure is lower than the stated pressure and you have
previously set the pre-set target pressure press the inflation start/stop button (1) to inflate the tyre.
Bicycle mode: default pressure (flashing) is 45 psi. Adjustable range: 15-100 psi.
5.
Motorcycle mode: default pressure (flashing) is 34 psi. Adjustable range: 14-51 psi.
To Next Page
Loading...
