The default pressure is PSI. To change to BAR or kPA press the mode button M (5) twice (pressure format
icon will flash) while flashing press the button to scroll between the pressure formats. Once the selected
format stops flashing the new selection is set.
To change the air pressure press the (6) buttons to increase or decrease the pressure setting
in 1.0 PSI/0.1 BAR/10 kPa increments. Press and hold the + or buttons and the target value will change
rapidly +5 PSI/0.5 BAR/50 kPa, release to stop. Once the display stops flashing the pressure is set.
Note this inflator has a deflate feature. If you find the current tyre pressure is higher than the desired
pressure press the deflation button (4) to reduce the pressure. If you remove too much air follow the
previous steps to inflate to the correct pressure.
WORKLIGHT
To switch the worklight on press & buttons together. To switch off press & together again.
To set a target pressure
12V POWER PLUG
TO REPLACE FUSE IN 12V PLUG
Undo knurled ring anti-clockwise
Fuse
Anti-clockwise
Replace fuse (15A MAX.) and knurled ring.
6.
+
_
+
_
+
+
_
&
+
_
To Next Page
Loading...
