• Regularly clean the nozzle (do not knock the torch head to remove debris.
Don’t remove the feeder device by pulling the torch cable.
• Use welding specific wire, not inferior or rusty wire.
Replace the feed roll if it is showing wear and tear to prevent wire from
feeding unevenly.
No touching inside cable or work piece while removing dust. While practicing to use
your new welder, experiment holding the torch in different positions until you find
the one that seems to work best for you.
• The welder voltage is high, so the safety
precautions should be implemented before
repairing to avoid accidental shock.
Under no circumstance can anyone except
authorised service agents should open the case
of the machine.
Switch off the power source each time when
To Next Page
Loading...
