It is recommended that while the unit is connected to a computer, the
mains adapter is used.
Looking after your Spirometer
Please observe the following precautions:
• Do not touch the screen with fingers. Use only the stylus provided.
• Use only a damp, lint free, cloth to clean the screen.
• Do not keep the spirometer in a damp place or expose it to extremes
of temperature.
• Do not direct the transducer holder towards a strong light source
while operating the spirometer.
• Check the AC charger for compatibility with local power rating.
Product Lifetime
The MicroLab spirometer is designed for a product lifetime of 7
years.
Cleaning Instructions
Disinfection of contaminated parts is only effective after having them
carefully pre-cleaned. Micro Direct recommends using a cold disinfectant
solution that is NOT chlorine or alcohol based for pre-cleaning and
disinfection. Please follow the manufacturer’s instructions.
The device must not be wiped with any aqueous solutions and must not
be exposed to solvents i.e. alcohol or chloride solutions as there are
electronic components inside that will be permanently damaged.
CAUTION: Switch off the device and always unplug the MicroLab before
cleaning.
External Surfaces of the Spirometer
CAUTION: Do not attempt to wash or immerse the MicroLab transducer
housing in water or cleaning fluid, as there are electronic components
inside that will be permanently damaged.
The external housing of the spirometer may be wipe with disinfecting
wipes or a damp cloth that has been immersed in a cold disinfectant
solution, when required.
CAUTION: Do not wipe the touch screen.
To Next Page
Loading...
Need help?
General