Micro Direct MicroLab User Manual

26
Safety Designation per IEC 60601-1
Type of protection against electrical shock
Internally powered
Equipment and Class I
Degree of protection against electrical
shock
Type B applied part
Power Equipment
Battery type: NiMH battery
pack, 8.4V, 1100mAh
Degree of Electrical connection between
equipment and patient
Equipment designed as
non-electrical connection
to the patient
Degree of mobility
Transportable
Mode of operation
Continuous
Classifications according to IEC 60601-1
MicroLab
Applied part, type B
Volume Transducer
Applied part, type B
WARNING: No modification of this equipment is allowed.
Note: When you connect other equipment to the unit, always make sure
that the whole combination complies with the international safety
standard IEC 60601-1 for medical electrical systems. During
measurements, connect the MicroLab only to printers and computers that
comply with IEC 60601-1 / ANSI/AAMI ES60601-1:2005 /CAN/CSA-
C22.2 No. 60601-1:14.
WARNING: The user must not touch any voltage carrying parts and the
patient at the same time.
During database upload, the MicroLab may be connected to a computer
that complies with EN 60950 – ‘Information technology equipment –
Safety – Part 1: General requirements’.
IMPORTANT: Only use the mains adapter supplied (PSU1012 12V DC
2.5A). The adapter contains a transformer. Do not cut off the adapter to
replace it with another plug as this causes a hazardous situation.
• The adapter transforms the mains voltage (100-240 Volts) to a
safe voltage (12V DC)
• Make sure the adapter does not get wet
• Do not use a damaged adapter
• Always unplug your MicroLab before cleaning
WARNING: Do not connect devices that are not specified as part of the
system.

Micro Direct MicroLab Specifications

General

Brand	Micro Direct
Model	MicroLab
Category	Medical Equipment
Language	English